Troubleshooting

Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assis- tance is needed, see the front cover of this manual. SYMPTOM: The power does not turn on

a.Make sure that the power cord is plugged into a properly earthed outlet (see page 15). If an exten- sion cord is needed, use only a 3-conductor, 14- gauge (1 mm2) cord that is no longer than 5 ft. (1.5 m).

b.After the power cord has been plugged in, make sure that the key is inserted into the console.

c.Check the power switch located on the treadmill frame near the power cord. If the switch protrudes as shown, the switch has tripped. To reset the power switch, wait for five minutes and then press the switch back in.

Tripped

Reset

SYMPTOM: The power turns off during use

a.Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console, and then reinsert it.

d.If the treadmill still will not run, please see the front cover of this manual.

SYMPTOM: The console displays remain lit when you remove the key from the console

a.The console features a display demo mode, de- signed to be used if the treadmill is displayed in a store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 23 to turn off the demo mode.

SYMPTOM: The displays of the console do not function properly

a.Press the Incline buttons and adjust the incline level of the treadmill to 5 percent.

Remove the key from the console and UNPLUG THE POWER CORD. With the help of a second person, carefully tip down the Uprights (85, 89).

There may be two Belly Pan Screws (A) in the bot- tom of the Belly Pan (84). If there are, remove them. Note: A Phillips screwdriver with a shaft at least 5 in. (13 cm) long is required.

a85