If you purchase the optional chest heart rate monitor (see page 23), follow the steps below to install the | ||
receiver included with the heart rate monitor. |
|
|
1. Make sure that the power cord is unplugged. | 1 | Console |
Remove the five M4 x 19mm Screws (35) and | ||
the two M4 x 45mm Screws (2) from the back of |
| Assembly |
the console assembly. |
|
|
| 2 | 35 | 2 |
|
| ||
| 35 | 35 | 35 |
2. Carefully lift the console assembly off of the | 2 |
|
|
Console Base (103). Locate the Pulse Wire (A) |
| Console | |
on the console assembly. |
|
| |
| 103 |
| Assembly |
|
|
| |
|
|
| A |
3. Connect the wire on the Receiver (B) to the | 3 | Antenna | |
Pulse Wire (A). |
| ||
Peel the paper backing off the pad on the bottom |
|
| Pad |
of the Receiver (B) and off the console pad. |
| B |
|
Next, hold the Receiver so that the antenna is |
|
| |
oriented as shown. Press the Receiver onto the |
|
| Console |
console pad. | Wire |
| |
Remove the Wire Holder (C). Place the wire on |
| Assembly | |
A |
| Console | |
the Receiver (B) between the two plastic pins |
| ||
and press the Wire Holder back on. |
|
| Pad |
4. See step 1. Reattach the console assembly. |
| C |
|
Make sure that no wires are pinched. Discard |
|
| |
the other wires included with the receiver. |
|
|
|
| 14 |
|
|
