Agilent Technologies J3919A, J3972A manual Connecting to the Network Out-of-Band

Installation

Connecting the Probe

Connecting to the Network (Out-of-Band)

You can connect the probe to an Out-of-Band telemetry network as described in one of the following topics. Figure 3-3 on page 51 shows both versions of the probe’s rear panel with the Token-Ring option installed.

“Connecting to 10MB/s Ethernet Telemetry Networks” below

z“Connecting to 10Base-T/100Base-TX Telemetry Networks” on page 52 “Connecting to Token-Ring Telemetry Networks” on page 54

CAUTION Do not touch the probe connector pins or the cable connector pins. Static discharge may damage equipment.

50