Agilent Technologies J3972A, J3919A manual OC-3 ATM Interface Configuration

Local Terminal Configuration

Using a Local Terminal

OC-3 ATM Interface Configuration

You must configure two of the three ports on the probe’s OC-3 ATM interface. The third port cannot be configured. Use the following procedure to configure items in the Modify/View Interface Values menu for the first port on the OC-3 ATM interface:

1.Press 3 to access the Modify/View interface values menu item. The Modify/View Interface Values menu for port 1 is displayed, as shown in Figure 2-7.

Modify/View Interface Values Menu - Firmware Rev

Interface Type		STS3C/STM1
1.	Port	3.1/STS3C-STM1
2.	Port Type	Monitor-only
3.	Cell Sychronization	HEC
4.	Cell Scrambling	On
S. Save changes and exit
0.	Cancel changes and exit

Figure 2-7: Modify/View Interface Values Menu (OC-3 ATM, Port 1)

2.Select each field requiring configuration (one at a time) by pressing its corresponding number and then entering the values that are appropriate for your network.

Port	Press 1 and then enter the OC-3 ATM interface’s port number
	to display the OC-3 ATM port’s configuration parameters
	along with their current settings. Refer to “Display Interface
	Summary” on page 36 for information on port types and port
	numbers for the installed interfaces. You can then view or
	configure the OC-3 ATM port’s configuration parameters.
Port Type	Press 2 and select the port type as Monitor-only.

33