
Local Terminal Configuration
Using a Local Terminal
Modify/View Interface Values Menu - Firmware Rev
Interface | Type | Serial | |
1. | Port |
| 1.2/Serial |
2. | Port Type | Not Applicable | |
3. | Serial | port IP address | 0.0.0.0 |
4. | Serial | port subnet mask | 255.255.252.192 |
5. | Serial | port speed | 9600 |
6. | Serial | port mode | Direct |
7. | Serial | port hardware flow control On | |
8. | Modem Init String | ^s^M^d1^sATE0Q0V1X4 S0=1... | |
9. | Modem Hangup String | ^d2^s+++^d2^sATH0^M^d2 | |
10. Modem | Connect Responses | /CONNECT/300/CONNECT/1200/... | |
11. Modem | /NO CARRIER/BUSY/NO DIALT... | ||
S. Save Changes and Exit |
| ||
0. | Cancel | Changes and Exit |
|
Figure 2-11: Modify/View Serial Port Settings Menu
2.Select each field requiring configuration (one at a time) by selecting its corresponding number as shown in Figure
Serial port IP address | Press 3 and then enter the serial port IP address for the |
| probe. The default Serial Port IP Address is 0.0.0.0. |
Serial port | Press 4 and then enter the serial port subnet mask for |
subnet mask | the probe (optional). It is recommended that you do not |
| change the serial port subnet mask unless there is a |
| conflict. The default Serial Port Subnet Mask is |
| 255.255.255.192. |
38