Agilent Technologies J3972A, J3919A manual Connecting the Probe to an OC-3 ATM Network

Installation

Connecting the Probe

1.Disconnect the cable between the ATM/OC-3 switch and router.

2.Connect the OC-3 ATMProbe’s Port 1 to the ATM/OC-3 Switch port that was just disconnected in Step 1. Figure 3-11 shows how to connect the probe to an OC-3 ATM network.

3.Connect the OC-3 ATMProbe’s Port 2 to the router port that was just disconnected in Step 1.

	In this connection scheme, the probe monitors network traffic as if the signal
	between the switch and Router is sent straight-through the probe.
NOTE	Port 1 of the probe’s OC-3 ATM Interface is for connecting to an ATM/OC-3
	switch and Port 2 is for connecting to a router. It might be necessary to swap
	cables.

Agilent OC-3 ATMProbe

Figure 3-11: Connecting the Probe to an OC-3 ATM Network

59