
Local Terminal Configuration
Using a Local Terminal
NOTE | If the | |
| Fast Ethernet interface or the | |
| Fast Ethernet interface comes from the factory configured as Telemetry and the | |
| ||
| “Disabled” in this case means that the interface does not function at all, not as a | |
| Telemetry port nor as a Monitor/Transmit port. If you configure the | |
| interface as Telemetry, the Fast Ethernet interface automatically becomes | |
| configured as Monitor/Transmit and is disabled. | |
| Port Type | Press 2 and select the port type as Telemetry. Making this |
| ||
|
| configuration change will disable the Ethernet telemetry port |
|
| (port 1). You can select either the |
|
| Ethernet interface (but not both) as the telemetry port. The |
|
| telemetry port does not maintain network statistics for the |
|
| |
|
| retrieval of ATM network statistics. Refer to “Fast Ethernet |
|
| Telemetry Interface Configuration” on page 25 for |
|
| information on configuring the Fast Ethernet interface. The |
|
| probe must be configured with exactly one telemetry port. |
| IP Address | Press 3 and enter the IP address for the probe. If the IP |
|
| address is 0.0.0.0, the probe will transmit Bootp Requests |
|
| for configuration information (including IP address) over the |
|
| network. This does not apply to ports configured as Monitor- |
|
| Only. |
| Default Gateway | Press 4 and enter the default gateway IP address for the probe |
| IP Address | (optional). |
| Subnet Mask | Press 5 and enter the subnet mask for the probe. |
| Press 6 to modify or view the network speed setting. | |
| Speed | The default configuration is set to 16 Mbps network speed. |
|
| You can enter values of 4 or 16 for 4 Mbps or 16 Mbps |
|
| respectively or enter Auto to automatically sense the ring |
|
| speed. |
31