![](/images/new-backgrounds/1184518/18451887x1.webp)
Local Terminal Configuration
Using a Local Terminal
Modify/View Security Values
Use the following procedure to configure items in the Modify/View Security Values menu:
1.If you want to restrict access to the probe press 2 to access the Modify/View security values menu item, otherwise skip this section. When you press 2, the Modify/View Security Values menu is displayed, as shown in Figure
Modify/View Security Values Menu - Firmware Rev
1. | Allow packet | capture | Yes |
2. | Allow TFTP firmware downloads | Yes | |
S. Save changes | and exit |
| |
0. | Cancel changes and exit |
|
Figure 2-4: Modify/View Security Values Menu
2.Select each field requiring configuration (one at a time) by pressing its corresponding number and then entering the values that are appropriate for your network. Refer to “Access Security” on page 8 for more information on security.
Allow Packet | Press 1 and enter Yes to allow or enter No to not allow |
Capture | packet capture. |
Allow TFTP | Press 2 and enter Yes to allow or enter No to not allow |
Firmware Downloads | TFTP firmware downloading. |
3.Press S to save the configuration changes and return to the probe’s Main Menu. If you want to cancel your current changes and return to the probe’s Main Menu, press 0.
24