Installation
Starting the Probe
Starting the Probe
NOTE | If you are using the Bootp server method of configuration, do not attach the power |
| cord to the probe until told to do so in Chapter 4 “Bootp Server Configuration”. |
| If you used the local terminal method of configuration, attach the power cord to |
| |
| the probe. The probe does not have a power switch, but is powered on when |
| power is attached. When powered on or reset, the probe runs |
| transmits ICMP echo frames to the default gateway for the purpose of allowing |
| the probe to be discovered by the routers (ARP cache). The probe transmits four |
| ICMP echo request packets about 10 seconds after booting and again every |
| autodiscovery echo interval. Refer to Chapter 5 “Probe Operation” for more |
| information on resetting the probe. |
68
