Local Terminal Configuration
Using a Local Terminal
Modify/View Configuration Values
Use the following procedure to configure items in the Modify/View Configuration Values menu:
1.Press 1 to access the Modify/View configuration values menu item. The Modify/View Configuration Values menu is displayed, as shown in Figure
Modify/View Configuration Values Menu - Firmware Rev
Memory configuration | x Mbytes | |
1. | Autodiscovery Echo Interval (sec.) | 1800 |
2. | Date | Wed 05/05/97 |
3. | Time | 09:12:00 |
4. | Time zone | PST8PDT |
S. Save changes and exit |
| |
0. | Cancel changes and exit |
|
Figure 2-3: Modify/View Configuration Values Menu
2.Select each field requiring configuration (one at a time) by pressing its corresponding number and then entering the values that are appropriate for your network.
Autodiscovery | Press 1 and enter the autodiscovery echo interval, in |
Echo Interval | seconds, as desired for your probe (optional). This parameter |
| sets the time interval for the probe to transmit an |
| autodiscovery frame, which is used by HP OpenView to |
| maintain its network map. |
| The default value is 30 minutes (1800 seconds). A value of |
| zero results in no transmission of autodiscovery frames. |
22
