Agilent Technologies J3919A, J3972A manual Display Interface Summary

Local Terminal Configuration

Using a Local Terminal

2.Review the parameters as needed.

3.Press S or 0 to return to the probe’s Main Menu.

Display Interface Summary

Use the following procedure to view the Display Interface Summary screen, as shown in Figure 2-10 on page 36. The Interface Type will show the cable type (such as V.11) if the cable type can be determined.

1.Press 4 from the Main Menu to access the Display Interface Summary item.

The Display Interface Summary item displays the number and type of each interface, the port type, and each port’s IP address.

2.Press Enter to continue from the probe’s Main Menu.

3.To exit the probe’s Main Menu, press 7 to execute a warm start or press 8 to execute a cold start. A cold start is required if you change the IP Address, Default Gateway or Subnet Mask. For either menu choice, the probe exits the Main Menu and restarts normal operations.

Display Interface Summary
Interface	Port Type	IP Address
------------	----------	-----------
1.1/Ethernet	Telemetry	15.6.72.216
1.2/Serial	Not Applicable	0.0.0.0
3.1/ATM	Monitor-only	Not Applicable
3.1/ATM-AL5	Monitor-only	Not Applicable
3.1/STS3C-STM1	Monitor-only	Not Applicable

Figure 2-10: Display Interface Summary

36