Agilent Technologies J3972A, J3919A manual Connecting to 10MB/s Ethernet Telemetry Networks

Installation

Connecting the Probe

Agilent J3919A

Agilent J3972A

Figure 3-3: The Probe’s Rear Panel (Token-Ring Option Shown)

Connecting to 10MB/s Ethernet Telemetry Networks

You can connect the probe to the network either by connecting the RJ-45 connector to a 10Base-T/100Base-TX half-duplex network or by connecting the AUI connector to a 10MB/s Ethernet network. Use the following procedures to connect the probe’s AUI connector to a 10MB/s Ethernet network for telemetry communications. Never use both the AUI and RJ-45 connectors.

51