Local Terminal Configuration
Using a Local Terminal
It requires the IP Address, Subnet Mask, and Default Gateway IP Address fields. The following apply to Telemetry ports:
|
|
| HP OpenView can discover the interface |
|
|
| The interface is IP addressable |
|
|
| The interface responds to |
|
|
| zThe interface will transmit all traps from the probe |
|
|
| The interface will transmit all extended RMON packets |
|
|
| sample from |
|
| IP Address | Press 3 and enter the IP address for the probe. If the IP |
|
|
| address is 0.0.0.0, the probe will transmit Bootp Requests |
|
|
| for configuration information (including IP address) over the |
|
|
| network. This does not apply to ports configured as Monitor- |
|
|
| Only. |
|
| Default Gateway | Press 4 and enter the default gateway IP address for the probe |
|
| IP Address | (optional). |
|
| Subnet Mask | Press 5 and enter the subnet mask for the probe. |
|
| Physical | Press 6 and select the physical connector. The menu only |
|
| Connector | shows the physical connectors that are available. You can use |
|
|
| the |
|
|
| (Link Speed and Full/Half Duplex) are not available. AUI is |
|
|
| 10MB/s |
|
|
| |
CAUTION | If you manually selected the Link Speed, be careful to configure it correctly. If | ||
|
| you configure the Link Speed for 100 MB/s and you connect the probe to a | |
|
| 10MB/s network, the probe will generate 100% utilization for that segment. | |
|
| Link Speed | Press 7 and select the Link Speed as Auto Negotiate, |
|
| ||
|
|
| 10MB/s, or 100MB/s. When you configure this parameter for |
|
|
| Auto Negotiate, the item 8 parameter (Full/Half Duplex) is |
|
|
| not available. |
28
