Bosch Appliances APC-AMC2-4WCF 5.6.3DIL Switch Address Selector, en Installing, AMC2 4W

34 en Installing AMC2 4W

Fig. 5.12 Settings for RS-485 four wire connection

For RS-485 four wire connection set the AMC-MUX DIL-Switch at the position 3, 5 and 6 to ON. On the upper side of the AMC panel put the jumper on the two pins on the right hand side of the connector 8 (see also: Figure 3.3). Set the RS-485 address of the AMC using the DIL-Switch - see Section 5.6.3 DIL Switch Address Selector.

NOTE!

i A complete connection diagram of the RS-485 host interface is shown in Figure 7.2.

5.6.3DIL Switch Address Selector

The first four DIL switches for address selection define the RS- 485 address of the AMC2 4Win a RS-485 bus system. Switch 5 selects on of the two different protocols, SDEB and BPA (according to DIN6619). Switch 6 sets the connection to the host system to either RS-232 or RS-485.

F.01U.024.965 V.4 2006.09 Installation manual Bosch Security Systems