AMC2 4W | Installing en 43 |
| Fig. 5.20 Schema of the using of the recovery diode |
|
|
! | Risk of Damage! |
Do not connect externally powered devices in wet mode. This | |
can damage the AMC2 4W. | |
|
|
|
|
i | NOTE! |
A complete connection diagram of the relay output connectors | |
is shown in Figure 7.9. | |
|
|
| Each relay output has a separate jumper setting on the bottom |
| side of the lower circuit board to activate wet (D2)or dry (D1) |
| mode. |
Bosch Security Systems | Installation manual | F.01U.024.965 V.4 2006.09 |
