Bosch Appliances APC-AMC2-4WUS, APC-AMC2-4WCF installation manual 3.2Equipment Configuration

AMC2 4W Introduction en 15

3.2Equipment Configuration

Fig. 3.3 Upper circuit board with display (top side)

1.Internal tamper contact

2.DIL switch for RS-485 address selection, protocol and RS- 232/RS-485 selection

3.Lithium battery for buffering of static RAM and real time clock (RTC). The battery shall be replaced by qualified per- sonnel every ten years or if indicated by an appropriate event.

4.Reset push button - available by using the srew driver

5.LC Display

6.Push button to select the display view - available by using the push button on the top of the housing

7.Jumper: Potential equalization between different mass sys- tems and protective earth (shield)

8.Jumper: interface selector RS-485 Host connection, RS- 485 two wire or RS-485 four wire (depends on external wiring)

9.Configurable RS-485 host interface (pluggable screw con- nector)

10.Docking station for the compact flash

Bosch Security Systems Installation manual F.01U.024.965 V.4 2006.09