Maxtor 2B020H1 SubsystemConfiguration, Jumper Location / Configuration, Jumper Configuration

PRODUCT DESCRIPTION

SubsystemConfiguration

Dual Drive Support

Two drives may be accessed via a common interface cable, using the same range of I/O addresses. The drives are jumpered as device 0 or 1 (Master/Slave), and are selected by the drive select bit in the Device/Head register of the task file.

All Task File registers are written in parallel to both drives. The interface processor on each drive decides whether a command written to it should be executed; this depends on the type of command and which drive is selected. Only the drive selected executes the command and activates the data bus in response to host I/O reads; the drive not selected remains inactive.

A master/slave relationship exists between the two drives: device 0 is the master and device 1 the slave. When the Master is closed (factory default, figure 2-1), the drive assumes the role of master; when open, the drive acts as a slave. In single drive configurations, the Master jumper must be closed.

Cable Select Option

CSEL (cable select) is an optional feature per ANSI ATA specification. Drives configured in a multiple drive system are identified by CSEL’s value:

–If CSEL is grounded, then the drive address is 0.

–If CSEL is open, then the drive address is 1.

Jumper Location / Configuration

JUMPER CONFIGURATION
Master/Slave
Only drive in single drive sys tem*	C
Master drive in dual drive system*	C
Slave drive in dual drive system	O
Cable Select
Disabled*		O
E nabled		C
Cylinder Limitation
Disabled*			O
E nabled			C
Factory Reserved				O
Key * = Default C = Closed (jumper installed) O = Open (no jumper)

Figure 2-1

PCBA Jumper Location and Configuration

Cylinder Limitation Jumper Description

On some older BIOS', primarily those that auto-configure the disk drive, a hang may occur. The Cylinder Limitation jumper reduces the capacity in the Identify Drive allowing large capacity drives to work with older BIOS'. The capacity reported when this jumper is closed will be as follows: drives less than or equal to 32GB will report 2.1GB. Drives greater than 32GB will report 32GB.

2 – 5