ProForm PCTL55810 user manual Pulse sensors, 7Whenkey. you are finished exercising, remove

Models: PCTL55810

1 26
Download 26 pages 22.59 Kb
Page 12
Image 12

The console can display

speed and distance in ei- ther miles or kilometers.

To change the unit of measurement, hold down

the STOP button while

inserting the key into the console. An “E,” for English miles, or an “M,” for metric kilometers, will appear in the SPEED/MIN-MILE display. Press the SPEED button to change the unit of measure- ment. When the desired unit of measurement is

selected, remove the key and then reinsert it.

6 Measure your heart rate, if desired.

Note: When using the pulse sensor, make sure that your hands are clean. The pulse sensor should also be kept clean with a damp cloth and mild detergent.

To measure

Sensors

your heart rate,

stand on the

 

foot rails and

 

place

both

 

thumbs

on the

 

pulse sensors

 

as shown.

Do

 

not press too

 

hard, or the cir-

 

culation in your

 

thumbs will be

 

restricted and

 

your pulse will

 

not be detected.

Next, wait until the heart-shaped

indicator in the CALS./FAT CALS./HEART RATE

display flashes steadily . After a few seconds, your heart rate will be shown. Hold your thumbs on the

sensor for another 15 seconds for the most accu- rate reading.

If the displayed heart rate appears to be too high

or too low, or if your heart rate is not displayed, lift your thumbs off the sensors and allow the display

to reset. Then, place your thumbs on the sensors

as described above. Try the pulsesensor several times until you become familiar with it. Remember

to stand still while measuring your heart rate.

7Whenkey. you are finished exercising, remove the

Step onto the foot rails, press the STOP button, and adjust the incline of the treadmill to the lowest level. The incline must be at the lowest level when the treadmill is raised to the storage po-

sition or the treadmill will be damaged.Next, re- move the key from the console and put the key in

a secure place. Note: If the displays and various indicators on the console remain lit after the

key is removed, the console is in the “demo” mode. Refer to page 14 and turn off the demo mode.

When you are finished using the treadmill, move the on/off switch near the power cord to the off position.

12

Page 12
Image 12
ProForm PCTL55810 user manual Pulse sensors, 7Whenkey. you are finished exercising, remove