ASSEMBLY
Assembly requires two people. | Set the treadmill in a cleared area and remove all packing materials. Do not | |
dispose of the packing materials until assembly is completed. | Assembly requires your own Phillips screw- | |
driver | and rubber mallet | . |
Note: The underside of the treadmill walking belt is coated with
WARNING: | Do not plug in the power |
cord until the treadmill is completely assembled.
1.With the help of a second person, carefully raise the treadmill to the upright position.
While a second person tips the treadmill to one side
slightly and holds it, insert one of the Extension Legs (103) into the treadmill as shown. Make sure that the Extension
Leg is turned so the Thick Base Pad (97) is on the bottom.
Next, tip the treadmill to the other side | and insert the |
other Extension Leg (not shown) in the same way. L | ower |
the side of the treadmill so that both Extension Legs |
|
(103)are resting flat on the floor.
2.With the help of a second person, carefully lower the treadmill frame and then tip the Uprights (82) down as shown. Note: It may be helpful to place your foot on the
wheel as you tip the Uprights. | Make sure that the |
Extension Legs (103) remain in the Uprights. |
|
Attach each Extension Leg (103) with two Screws (101) and a Base Pad (119) as shown.
Note: One replacement Base Pad (119) and Spacer (not shown) may be included. If a Base Pad becomes worn
and needs to be replaced, use the replacement Base
Pad. If a Thick Base Pad (97) needs to be replaced, use the replacement Base Pad with the Spacer.
1 |
|
|
| 103 | 82 |
|
| |
| 97 |
|
2 |
| 97 |
|
| |
|
| 119 |
|
| 101 |
|
| 103 |
|
| 97 |
|
| 119 |
82 |
| 101 |
|
| |
|
| 101 |
|
| 103 |
|
| 97 |
6
