ProForm PCTL55810 user manual Problem The walking belt slows when walked on, Shifted to the left

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 9.

b. If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be-

come damaged. Remove the key andUNPLUG THE

POWER CORD . Using the allen wrench, turn both rear roller adjustment bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each side of the walking belt 7 to

10 cm (3 to 4 in.) off the walking platform. Be careful to keep the walking belt centered. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

b	7–10 cm
Rear Roller Adjustment Bolts

c. If the walking belt still slows when walked on, call our Customer Service Department, toll-free.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION:	a. If the walking belt is off-center, first remove the key and
	UNPLUG THE POWER CORD			. If the walking belt has
	shifted to the left,	use the allen wrench to turn the left
	rear roller bolt clockwise 1/2 of a turn;			if the walking belt
	has shifted to the right,		turn the bolt counterclockwise
	1/2 of a turn. Be careful not to overtighten the walking
	belt. Plug in the power cord, insert the key and run the
	treadmill for a few minutes. Repeat until the walking belt is centered.

a

b. If the walking belt slips when walked on, first remove the

key and UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller bolts clockwise, 1/4 of a turn.

When the walking belt is correctly tightened, you should

be able to lift each side of the walking belt 7 to 10 cm (3 to 4 in.) off the walking platform. Be careful to keep the walking belt centered. Plug in the power cord, insert the key and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

b

PROBLEM: The incline of the treadmill does not change correctly
SOLUTION:	a. With the key inserted in the console, press one of the INCLINE buttons.		While the incline is
	changing, remove the key.	After a few seconds, re-insert the key. The treadmill will automati-
	cally rise to the maximum incline level and then return to the minimum level. This will recalibrate
	the incline.

18