ASSEMBLY
Assembly requires two persons. Place all parts of the recumbent cycle in a cleared area and remove the pack- ing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included
tools, assembly requires an adjustable wrench 
and a Phillips screwdriver 
.
Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers to the quantity needed for assembly. Note: Some small parts may have been
M8 Flat | M8 Curved | M8 Nylon | M8 Nylon |
Washer | Washer | Locknut | Locknut |
M6 x 25mm | M6 x 38mm | M8 x 15mm | M8 x 20mm |
Hex Screw | Hex Screw | Button Screw | Button Screw |
M4 x 16mm | M4 x 8mm |
|
|
Screw | Ground Screw | M8 x 70mm Carriage Bolt | |
1.Identify the Front Stabilizer (2), which is shorter than the Rear Stabilizer (not shown). Attach the Front Stabilizer to the front of the Frame (1) with two M8 x 70mm Carriage Bolts (66), two M8 Curved Washers (28), and two M8 Acorn Nuts (56).
1 |
2 |
66 |
1 |
28 |
56 |
5
