HP unix manual Positioning the Hard Disk Drive Assembly

Field Replaceable Units

FRU Removal and Replacement

5.Slide the hard disk drive assembly into its slot, and push inward firmly until the front of the hard disk drive bracket is flush with the hard disk drive connector on the system board. See Figure 4-33. The bracket hooks will lock into the chassis rail.

Figure 4-33. Positioning the Hard Disk Drive Assembly

T-15 Torx Thumbscrew

6.Tighten the T-15 Torx thumbscrew to secure the hard disk drive assembly to the system board.

7.Close the left side panel of the workstation as shown in the section “Closing the Left Side Panel.”

Chapter 4 109