HP unix manual Installing the Floppy Disk Drive Blank and Bracket

Field Replaceable Units

FRU Removal and Replacement

If you will replace the floppy disk drive with a blank, continue on with step 7 below. However, if you will replace it with a new floppy disk drive, go to step 6 in the section “Replacing or Installing a Floppy Disk Drive” on page 101.

7.Place the floppy disk drive blank in the floppy disk drive bracket and tighten the four floppy disk drive mounting screws (T-15 Torx/slotted screws) into the bracket. See Figure 4-15.

Figure 4-15. Installing the Floppy Disk Drive Blank and Bracket

Floppy Disk

Drive Bracket

Floppy Disk Drive

Mounting Screws

Floppy Disk

Drive Blank

Floppy Disk Drive

Mounting Screws

8.Slide the floppy disk drive blank and its bracket into the workstation chassis as shown in Figure 4-15.

9.Tighten the two floppy disk drive bracket screws as shown in Figure 4-16.

Figure 4-16. Tightening the Bracket Screws

Bracket Screw

Bracket Screw

98 Chapter 4