HP unix manual Dimm table is full--cannot add new

				Troubleshooting
				Selftest Failures
Table 3-2. Chassis Codes for the B2000 Workstation
Ostat	Code	FRU	Message	Description
FLT	7207	DIMM	DIMM table full	The DIMM table is full--cannot add new
				type.
FLT	7208	DIMM	no DIMMs found	SPD didn’t find any memory DIMMs.
INI	721s	DIMM	is DIMM s inst?	SPD is checking memory slot s.
INI	722s	DIMM	???? DIMM in s	SPD found a DIMM in slot s, but can’t
				determine its size. DIMM will not be used.
INI	723s	DIMM	128M DIMM in s	SPD found a 128MB DIMM in slot s.
INI	724s	DIMM	256M DIMM in s	SPD found a 256MB DIMM in slot s.
INI	725s	DIMM	512M DIMM in s	SPD found a 512MB DIMM in slot s.
FLT	72As	DIMM	DIMM s checksum	DIMM in slot s failed SPD checksum and
				will not be used.
FLT	72Cs	DIMM	DIMM s mismatch	DIMM in slot s didn’t match the other in
				pair. (J7000 only--DIMMs must be in
				matched pairs.)
FLT	72Ds	DIMM	DIMM s load err	Memory DIMMs are not in the proper
				order. As a result, the system cannot
				access DIMM s and has deallocated it.
INI	7300	SYS BD	mem config start	Starting main memory configuration.
TST	7301	SYS BD	check mem config	Checking for memory configuration
				change since last boot.
WRN	7302	SYS BD	mem confg changd	Memory physical configuration changed
				since last boot.
INI	7303	SYS BD	use confg change	Memory physical configuration didn’t use
				saved configuration change. Use stored
				configuration data.
INI	7304	SYS BD	build mem intrlv	Building memory configuration with all
				DIMMs interleaved.
INI	7305	SYS BD	save mem config	Saving memory configuration information
				in non-volatile memory.
WRN	7306	SYS BD	use alt mem conf	Memory will be configured from fixed
				values, instead of detected DIMMs.
INI	7307	SYS BD	interleve memory	Generating the memory interleave.
FLT	7308	SYS BD	PDT is disabled	Firmware detected bad memory pages,
				but the Page Deallocation Table is
				disabled.

Chapter 3 63