HP unix manual Replacing the CD Drive Bay’s Rear Cover

Field Replaceable Units

FRU Removal and Replacement

12.Make sure that the audio, ATAPI, and power cables are positioned so that they will come out of the bottom edge of the CD drive bay’s rear cover when it is replaced. (Note that the rear cover’s bottom edge is rounded to prevent cutting of the cables.) To replace the rear cover, place the end opposite of the rear cover handle into the cover slot and rotate it into place. Tighten the T-15 Torx/slotted screw to secure the rear cover. Note that, when you replace the rear cover, the ferrite bead on the ATAPI cable must remain outside of the CD drive bay’s rear cover. See Figure 4-11.

Figure 4-11. Replacing the CD Drive Bay’s Rear Cover

Rear Cover

T-15

Torx/Slotted

Screw

Ferrite Bead

13.Make sure that all cables are positioned within the workstation so that they cannot be damaged. Then close the left side and front panels of the workstation as shown in the sections “Closing the Left Side Panel” and “Closing the Front Panel.”

Chapter 4 95