
Troubleshooting
Selftest Failures
Selftest Failures
Chassis codes are the key to debugging selftest errors. If a failure is found during selftest, chassis codes are displayed in the LCD. The procedure for using these codes to debug a failure is as follows:
1.Using Table
2.To get additional information about failures from the Boot Console Handler, use the Service Menu’s pim, pdt, and ChassisCodes commands.
In the following table, the FRU column shows messages printed on the LCD that refer to system FRUs. Only FLT codes have FRUs associated with them. Some WRN codes are also device specific, especially to IODC calls; for example, 8xxx codes. TST and INI codes do not necessarily correspond to any FRU. All codes are listed in numeric order.
NOTE | Because the B2000 workstation is a |
| I/O BD (I/O board) in chassis codes displayed on the LCD and listed in Table |
| |
|
|
Chapter 3 | 53 |