HP unix manual Initializing serial LDB port as console

				Troubleshooting
				Selftest Failures
Table 3-2. Chassis Codes for the B2000 Workstation
Ostat	Code	FRU	Message	Description
INI	91DB	IO BD	init SERIAL_LDB	Initializing serial LDB port as console
				display.
INI	9C51	IO BD	consol is SER_1	Console display is on serial port 1.
WRN	9C51	IO BD	bad init SERIAL1	Serial port 1 failed to initialize as a
				console device.
INI	9C52	IO BD	consol is SER_2	Console display is on serial port 2.
WRN	9C52	IO BD	bad init SERIAL2	Serial port 2 failed to initialize as a
				console device.
INI	9C6s	EXT IO	consol is GRAPHs	Console display is on graphics card in PCI
				slot s.
WRN	9C6s	EXT IO	bad PCI slot s	Graphics in PCI slot s failed to initialize
				as a console device.
INI	9C8t	EXT IO	cnfg mon type t	Set graphics console to monitor type t.
				(Seen when cycling through types.)
WRN	9C8t	EXT IO	mon type t fail	Failed to configure console to monitor type
				t.
INI	9CDB	IO BD	consl is SER_LDB	Console display is on serial LDB port.
WRN	9CDB	IO BD	bad init SER_LDB	Serial LDB port failed to initialize as a
				console device.
FLT	A088	IO BD	consl path fault	Unable to boot--no console device found.
WRN	A008	EXT IO	no boot device	Unable to boot--no bootable device found.
WRN	A0BD	EXT IO	device not ready	Boot device not ready--operation may be
				retried.
FLT	A0FF	EXT IO	unknown launch	Unable to boot. Explanation may appear
				on console.
WRN	A50F	EXT IO	init pri pth err	Unable to boot from primary boot device.
WRN	A70F	EXT IO	init otr pth err	Unable to boot from non-primary boot
				device.
INI	C10m	SYS BD	CPUm is monarch	CPU m was chosen as the monarch
				processor. (All other CPUs are slaves.)
INI	C30m	SYS BD	monarchm test	CPU m finished the monarch-only tests
				and system initialization.
INI	C30C	SYS BD	mnrch slv chck	The monarch CPU is checking whether
				the slaves are in the correct rendezvous.

Chapter 3 69