®
ELECTRIC CHAIN SAW
PRODUCT
IDENTIFICATION
Front Hand
Guard
Saw
Chain
Rear
Handle
Guide Bar
Nose
Guide Bar
Spike
Rear Hand
Guard
ASSEMBLY
WARNING: Cutting edges on chain are sharp. Use protective gloves when handling chain.
IMPORTANT: Do not clamp chain saw in vise during assembly.
1. | Lay chain out flat. |
2. | Remove guide bar nuts from guide bar |
| bolts (see Figure 3, page 7). |
3. | Turn adjusting screw counterclockwise |
| (see Figure 4, page 7). Continue to turn |
| adjusting screw until adjusting block is |
| to rear of adjusting plate. |
4. | Install guide bar onto saw body. Place |
| rear of guide bar between adjusting |
| plate and sprocket support. |
Power Cord
Front
Handle
Motor
Housing
Scabbard
Oil Level Sight Hole (located on saw body, hidden by front handle)
Oil Cap With
Squeeze Bulb
Switch
Lockout
Trigger
IMPORTANT: Make sure to insert ad- |
justing block into oval adjusting hole |
on guide bar. |
5. Attach guide bar nuts to guide bar bolts. |
IMPORTANT: Tighten guide bar nuts |
finger tight only. Make sure adjusting block |
is in oval adjusting hole on guide bar. |
6. Place chain around drive sprocket, then |
along top groove of guide bar and |
around guide bar nose. Note: Make |
sure cutting edges of chain are facing |
the right direction. Position chain so |
cutting edges on top of guide bar face |
guide bar nose (see Figure 3, page 7). |
CAUTION: Do not place chain on saw backwards. If chain is backwards, saw will vibrate badly and will not cut.
Figure 2 - Electric Chain Saw
UNPACKING
1.Remove all items from carton.
2.Check all items for any shipping dam- age. If you find any damage or if any parts are missing, promptly inform dealer where you bought chain saw.
7.Adjust saw chain tension. Follow steps under Saw Chain Tension Adjustment, page 8.
8.If saw has
6 | 102891 |
