®
ELECTRIC CHAIN SAW
CLEANING AND MAINTENANCE
Continued
Filing Cutter Depth Gauges
The cutter depth gauge clearance is reduced as cutters are sharpened. After every second or third sharpening, reset cutter depth gauges.
1.Place depth gauge tool firmly across top of two cutters. Make sure depth gauge enters slot in depth gauge tool (see Fig- ure 22).
2.Use medium flat file. File depth gauge level with depth gauge tool.
3.Remove depth gauge tool. With flat file, round off front corner of cutter depth gauge (see Figure 23).
After several hand filings, have authorized service center or sharpening service machine sharpen chain. This will insure even filing.
Depth
Gauge
Flat File
Depth
Gauge
Tool
Depth
Gauge
Slot
Figure 22 - Depth Gauge Tool On Chain
Front Corner
Replacing Saw Chain
Replace chain when cutters are too worn to sharpen or when chain breaks. Only use replacement chain noted in this manual. Al- ways include new drive sprocket when re- placing chain. This will maintain proper driv- ing of chain. Note: For proper chain and drive sprocket, see Replacement Parts.
RECYCLING
In the event it is not practical to repair your chain saw, be sure to follow local and coun- try codes for recycling plastic and metallic materials when disposing of the unit.
STORAGE
If storing saw for more than 30 days, follow steps below.
1.Drain oil tank.
2.Remove and clean guide bar and chain. Clean guide bar and chain by soaking in petroleum based solvent or mild soap and water mixture.
3.Dry guide bar and chain.
4.Place chain in container filled with oil. This will prevent rust.
5.Wipe a thin coating of oil over surface of guide bar.
6.Wipe off outside of saw body. Do this with soft cloth dampened with a mild soap and water mixture.
7.Store chain saw
•in a high or locked place, out of children’s reach
•in a dry place
•in a carrying case or with scabbard over guide bar
REPLACEMENT PARTS
WARNING: Use only replace- ment parts described in this manual. Use of other parts could damage saw or injure operator.
Purchase these parts from your local dealer.
Part Number | Description |
Guide bar, 350 mm | |
Chain, 350 mm | |
Drive sprocket |
Figure 23 - Round Off Front Corner Of Depth Gauge
14 | 102891 |