OWNER’S MANUAL
TROUBLESHOOTING
WARNING: Unplug chain saw from power source before servicing. Severe injury or death could occur from electrical shock or body contact with moving chain.
OBSERVED FAULT | POSSIBLE CAUSE | REMEDY | ||
Saw runs, but does not cut | 1. | Chain assembled backwards on guide | 1. | See Assembly, pages 6 and 7 |
|
| bar |
|
|
|
|
|
|
|
Saw does not cut unless heavily forced. | 1. | Chain is dull | 1. | See Sharpening Your Saw Chain, pages |
Cutting produces only sawdust with few |
|
|
| 13 and 14 |
large chips |
|
|
|
|
|
|
|
|
|
Saw runs slow. Saw stalls easily | 1. | Low power supply voltage | 1. | Extension cord wire size too small. See |
|
|
|
| Extension Cords, page 8 |
|
|
|
|
|
Motor of saw does not run when you squeeze | 1. | Switch lockout not pressed in to release | 1. | Press in switch lockout before squeez- |
trigger |
| trigger |
| ing trigger |
| 2. | Chain brake activated | 2. | Release trigger and move front hand |
|
|
|
| guard back towards rear of saw |
| 3. | Extension cord connections loose | 3. | Check cord connections |
| 4. | Open line fuse or circuit breaker | 4. | Check line fuse or circuit breaker |
| 5. | Bad motor brushes | 5. | Contact authorized service person |
|
|
|
|
|
Motor of saw runs, but chain does not move | 1. | Open wiring circuit on saw | 1. | Contact authorized service person |
| 2. | Gear train failure | 2. | Contact authorized service person |
|
|
|
|
|
Chain does not get oil | 1. | Clogged oil slot in guide bar | 1. | Remove guide bar and clean oil slot |
| 2. | Oil is too thick | 2. | Use correct weight of oil. See Filling Oil |
|
|
|
| Tank, page 7 |
|
|
|
|
|
Chain comes off guide bar | 1. | Chain is loose | 1. | Tighten chain. See Saw Chain Tension |
|
|
|
| Adjustment, page 8 |
| 2. | Guide bar and chain not assembled right | 2. | See Assembly, pages 6 and 7 |
|
|
|
|
|
Saw smokes | 1. | Saw damaged. Do not use saw | 1. | Contact authorized service person |
|
|
|
|
|
Saw leaks oil | 1. | Oil cap is not secure | 1. | Tighten oil cap. Note: Empty oil tank |
|
|
|
| when not in use |
|
|
|
|
|
Chain brake does not stop saw chain | 1. | Brake failure | 1. | Contact authorized service person |
102891 | 15 |