4.Insert the Weight Tube (11) into a Weight (17).
Make sure the indicated slot in the Weight is oriented as shown. Center the Roll Pin (54) into the indicated hole in the Weight Tube. Note: The Roll Pin must be below the Weight.
5.Orient the two Weight Guides (10) with the indi- cated hole closer to the bottom (see the inset drawing).
Insert the two Weight Guides (10) into the indicat- ed holes in the Base (1). Attach the Weight Guides with two M8 x 115mm Bolts (76), four M8 Washers (72), two 38mm Spacers (48), and two M8 Nylon Locknuts (74).
Slide the two Weight Bumpers (50) onto the Weight Guides (10). Next, slide eleven Weights
(17)onto the Weight Guides one at a time. Make sure the indicated slot in each Weight is ori- ented as shown. Then, slide the Weight Tube
(11)and Weight (17) onto the Weight Guides.
4 |
|
|
|
| 54 |
11 |
|
|
|
| 17 |
|
| Slot |
5 |
| 10 |
10 |
| |
|
| |
| 17 | |
| 11 |
|
|
| Holes |
|
| 17 |
|
| Slot |
76 | 50 |
|
72 |
|
|
48 |
|
|
1 | 72 | 74 |
| ||
7
