ASSEMBLY
•To hire a service technician to assemble this product in your home, call
•Assembly requires two persons.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps.
•The underside of the walking belt is coated with
•To identify small parts, see page 6.
•Assembly requires the following tools:
the included hex keys
one adjustable wrench one Phillips screwdriver scissors needlenose pliers
To avoid damaging parts, do not use power tools.
1.Make sure that the power cord is unplugged. With the help of a second person, carefully tip the treadmill onto its left side. Partially fold the Frame (55) so that the treadmill is more stable; do not fully fold the Frame yet.
Locate the Upright Wire (85), which is bundled at the front of the Base (94). Remove the pack- aging from the Upright Wire. Insert the Upright Wire into the end of the Base and pull it out of the indicated hole. If necessary, use the plastic tie to pull the Upright Wire out of the hole. Attach two Base Feet (92) and two Base Foot Spacers (36) to the Base (94) in the locations shown with two #8 x 1" Tek Screws (2).
Then, attach the other two Base Feet (92) with two #8 x 1" Tek Screws (2).
See the inset drawing. Cut the plastic tie near the Upright Wire (85).
1 |
|
| Hole |
|
85 Tie |
| 92 2 | ||
55 |
|
|
|
|
36 92 |
|
| 94 |
|
2 |
| 92 |
| |
|
| 2 | ||
|
|
| ||
|
|
| Tie |
|
36 |
| 922 | 85Cut |
|
7
