13. Turn on the power (see page 16). See step 4 | 13 |
|
|
|
on page 17 and lower the incline to the low- | 55 |
| 6 | |
est position. Then, remove the key from the |
|
| ||
console, switch the reset/off circuit breaker to |
|
|
|
|
the “off” position, and unplug the power cord. |
|
|
|
|
Raise the Frame (55) to the position shown. |
|
|
|
|
Have a second person hold the Frame until |
|
|
|
|
this step is completed. |
|
|
|
|
Orient the Storage Latch (51) so that the |
|
|
|
|
large barrel and the Latch Knob (52) are po- |
|
| 52 |
|
sitioned as shown. |
|
|
| |
Attach the upper end of the Storage Latch (51) |
|
| 51 |
|
to the Frame (55) with a 3/8" x 1 3/4" Patch Bolt |
|
|
| |
(6). |
|
| Large |
|
Attach the lower end of the Storage Latch (51) to |
|
| Barrel |
|
the Base (94) with a 3/8" x 2" Bolt (3) and a 3/8" |
|
|
|
|
Nut (10). Note: It may be necessary to move the |
|
|
|
|
Frame (55) back and forth to align the Storage |
|
| 10 |
|
Latch with the Base. |
|
|
| |
Lower the Frame (55) (see HOW TO LOWER |
|
| 94 |
|
THE TREADMILL FOR USE on page 24). |
|
| 3 | |
|
|
|
|
14.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see pages 26 and 27).
13
