1.Make sure that the power cord is unplugged. With the help of a second person, carefully tip the treadmill onto its left side. Partially fold the Frame (55) so that the treadmill is more stable; do not fully fold the Frame yet.
Locate the Upright Wire (85), which is bundled at the back of the Base (94). Remove the pack- aging from the Upright Wire. Insert the Upright Wire into the Base and pull it out of the indicated hole. If necessary, use the plastic tie to pull the Upright Wire out of the hole.
Hold a Wheel (95) inside a Wheel Housing (96). Press a Wheel Axle (97) through the Wheel. Next, press the Wheel Housing into the end of the Base (94). Make sure that the tab on the Wheel Housing is positioned as shown.
Attach the other Wheel (95) in the same way.
2.Attach four Base Feet (92) to the Base (94) in the locations shown with four #8 x 1" Tek Screws
(2).
See the inset drawing. Cut the plastic tie near the Upright Wire (85).
1 | HoleTie | 85 | 94 |
|
|
| |||
|
|
| ||
| 55 |
|
|
|
97 | 9796Tab |
|
|
|
|
|
|
| |
95 | 96 |
|
|
|
| Tab |
|
|
|
2 | Tie |
| 92 2 | |
| 85 |
| ||
| 92 2 |
| 94 |
|
|
| 92 | 2 | |
|
|
| ||
922 | Tie |
85Cut |
7
