Remove the three #8 x 3/4" Screws (1) and care- |
|
|
fully pivot the Motor Hood (62) off. | 1 | 1 |
62 |
Locate the Reed Switch (69) and the Magnet (48) |
|
|
on the left side of the Pulley (50). Turn the Pulley |
|
|
until the Magnet is aligned with the Reed Switch. |
|
|
Make sure that the gap between the Magnet and | 1/8 in. |
|
the Reed Switch is about 1/8 in. (3 mm). If nec- |
| |
essary, loosen the #8 x 3/4" Clamp Screw (17), | 69 | 48 |
move the Reed Switch slightly, and then retighten | ||
the Screw. | Top | 50 |
Reattach the Hood (not shown) with the #8 x 3/4" | View |
|
Screws (not shown). Reattach the #8 x 2" Screws |
|
|
(not shown) if necessary. Run the treadmill for a |
|
|
few minutes to check for a correct speed reading. |
|
|
PROBLEM: The incline of the treadmill does not change correctly |
|
|
SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds,
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a
b. If the walking belt is overtightened, treadmill perfor- | b |
|
mance may decrease and the walking belt may be- | ||
come damaged. Remove the key and UNPLUG |
| |
THE POWER CORD. Using the hex key, turn both |
|
|
idler roller bolts counterclockwise, 1/4 of a turn. |
|
|
When the walking belt is properly tightened, you |
|
|
should be able to lift each edge of the walking belt |
|
|
2 to 3 in. (5 to 7 cm) off the walking platform. Be |
|
|
careful to keep the walking belt centered. Then, |
|
|
plug in the power cord, insert the key, and run the | Idler Roller Bolts | |
treadmill for a few minutes. Repeat until the walk- | ||
ing belt is properly tightened. |
|
|
c. If the walking belt still slows when walked on, see the front cover of this manual.
23
