
| Locate the Reed Switch (52) and the Magnet (50) | 
 | 
 | 
| on the left side of the Pulley (49). Turn the Pulley | 
 | 
 | 
| until the Magnet is aligned with the Reed Switch. | 
 | 
 | 
| Make sure that the gap between the Magnet and | 52 | 49 | 
| the Reed Switch is about 1/8 in. (3 mm). If nec- | ||
| essary, loosen the #8 x 3/4" Tek Screw (14), move | 14 | 50 | 
| the Reed Switch slightly, and then retighten the | 1/8 in. | 
 | 
| Screw. Reattach the Motor Hood (not shown) and | 
 | 
 | 
| run the treadmill for a few minutes to check for a | Top | 
 | 
| correct speed reading. | 
 | |
| 
 | View | 
 | 
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a. Recalibrate the incline system (see step 3 on page 27).
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a 
| b. If the walking belt is overtightened, treadmill perfor- | b | 
 | 
| mance may decrease and the walking belt may be- | ||
| come damaged. Remove the key and UNPLUG | 
 | |
| THE POWER CORD. Using the hex key, turn both | 
 | 
 | 
| idler roller bolts counterclockwise, 1/4 of a turn. | 
 | 
 | 
| When the walking belt is properly tightened, you | 
 | 
 | 
| should be able to lift each edge of the walking belt | 
 | 
 | 
| 2 to 3 in. (5 to 7 cm) off the walking platform. Be | 
 | 
 | 
| careful to keep the walking belt centered. Then, | 
 | 
 | 
| plug in the power cord, insert the key, and run the | Idler Roller Bolts | |
| treadmill for a few minutes. Repeat until the walking | ||
| belt is properly tightened. | 
 | 
 | 
| c. If the walking belt still slows when walked on, see the front cover of this manual. | ||
| PROBLEM: The walking belt is  | 
 | 
 | 
| SOLUTION: a. If the walking belt is  | a | 
 | 
| key and UNPLUG THE POWER CORD. If the | 
 | |
| walking belt has shifted to the left, use the hex | 
 | 
 | 
| key to turn the left idler roller bolt clockwise 1/2 of a | 
 | 
 | 
| turn; if the walking belt has shifted to the right, | 
 | 
 | 
| turn the left idler roller bolt counterclockwise 1/2 of | 
 | 
 | 
| a turn. Be careful not to overtighten the walking | 
 | 
 | 
| belt. Then, plug in the power cord, insert the key, | 
 | 
 | 
| and run the treadmill for a few minutes. Repeat | 
 | 
 | 
| until the walking belt is centered. | 
 | 
 | 
31
