ProForm PFTL14511.0 warranty Make sure that the power cord is unplugged

1.	Make sure that the power cord is unplugged.	1
	Place a piece of cardboard below the rear of the
	Frame (56) to protect the floor or carpet.
	Attach the Left Wheel Cap (96) to the Base (94)					56
	with two #8 x 3/4" Screws (2).
	Attach the Right Wheel Cap (not shown) to
	the right side of the Base (94) in the same
	way.		94	2
					96 Cardboard
2. Pull the Upright Wire (81) and the Base Ground		2
	Wire (110) through the indicated hole in the
	Base (94).
	Attach the Base Ground Wire (110) to the Base			Hole
	(94) with a #8 x 1/2" Ground Screw (10).
				81
				10	110	94
3. Identify the Left Upright (89), which is marked		3
	with a “Left” sticker or an “L” sticker. Have a sec-			81
	ond person hold the Left Upright near the Base
	(94).					89
	See the inset drawing. Tie the wire tie in the
						Wire
	Left Upright (89) securely around the end of the						81
	Upright Wire (81). Then, pull the other end of the					Tie
	wire tie until the Upright Wire is routed com-			Wire
	pletely through the Left Upright.
			89	Tie
				81	94
		7