Filename [M150SEK_10Subsidiary.fm]

 

M150SEK_00.book Page 59 Wednesday, June 15, 2005 4:04 PM

Masterpage:Right0

 

SYSTEM CONNECTIONS EN 59

Connecting To A Satellite Receiver

Connect the satellite receiver to the [L-2 IN] connector, then connect the [L-1 IN/OUT] connector to the TV’s connector.

NOTES:

Set AL-2 SELECTB to AVIDEO/RGBB or AS-VIDEO/RGBB. (A pg. 58)

You can use the Automatic Satellite Programme Recording function with this connection. (A pg. 42)

To record a programme via the satellite receiver, select L-2 mode by pressing PR +/– so that AL-2Bappears on the front display panel.

For details, refer to the instruction manual of the satellite receiver.

Outdoor unit

Aerial

Satellite cable

TV aerial cable

Satellite receiver

ANTENNA IN

ANTENNA OUT

TV

Rear of unit

IMPORTANT

When you set AL-2 SELECTB to ASAT VIDEO/RGBB or ASAT S-VIDEO/RGBB(A pg. 58), it is possible to view a satellite broadcast with the TV set to an input mode such as EXT1 even if the unit is turned off. When the unit is in Stop mode or recording, press TV/VIDEO on the remote control to turn off the Video indicator on the front display panel.

If you turn on the unit when the satellite receiver’s power is off, nothing appears on the TV screen. In this case, turn on the satellite receiver, or set the TV to its TV mode, or slide the TV/ DVD switch to TV to set the unit to the AV mode.

Connecting To A Dolby Digital Decoder Or An Amplifier With Built-in DTS

These instructions enable you to connect your unit to a Dolby Digital Decoder or an amplifier with built-in DTS.

Dolby Digital Decoder or amplifier with built-in DTS

To DIGITAL AUDIO

input

Coaxial cable (not supplied)

To [DIGITAL OUT (COAXIAL)]

Rear of unit

1Connect the unit and a Dolby Digital Decoder or an amplifier with built-in DTS using an optional coaxial cable.

NOTE:

For details on [DIGITAL AUDIO OUT] connector setting, refer to ADIGITAL AUDIO OUTB. (A pg. 60)

Page 59
Image 59
JVC DR-M150SEK manual Connecting To a Satellite Receiver