Filename [M150SEK_05Name.fm]
Masterpage:Left+
18 EN INITIAL SETTINGS
Results Of Auto Set Up Appearing On The Front
Display Panel
If both Auto Channel Set and
Auto Clock Set have been
performed successfully, the
correct current time is displayed.
Turn on the TV and select an input mode such as EXT1, then make
sure that all necessary stations have been stored in the unit’s
memory by using the PR +/– button(s).
●If station names have also been stored in the unit’s memory, the
station name will be displayed at the top right corner of the TV
screen for about 5 seconds when the unit is tuned to a different
station.
●If you want to set the tuner manually such as to add or skip
channels, or to set or change station names, see pages 64 and
65.
If Auto Channel Set has
succeeded but Auto Clock Set
has not, A1B is displayed.
OR
If both Auto Channel Set and Auto Clock Set have failed,
AcB is displayed.
ATurn on the TV and select an input mode such as EXT1, then
make sure that all necessary stations have been stored in the
unit’s memory by using the PR +/– button(s).
●If station names have also been stored in the unit’s memory, the
station name will be displayed at the top right corner of the TV
screen for about 5 seconds when the unit is tuned to a different
station.
●If you want to set the tuner manually such as to add or skip
channels, or to set or change station names, see pages 64 and
65.
BPerform AClock SetB (Apg. 66).
ATTENTION:
After making sure the cables are connected properly, turn off the
unit’s power once, then turn the unit’s power back on again.
Perform AAuto Set UpB (Apg. 17) again.
IMPORTANT:
●To check if the channel numbers have been set correctly, perform
timer programming. (Apg. 37)
●In certain reception conditions, station names may not be stored
correctly. When programming timer recording, be sure to check
that the desired channel is selected correctly. (Apg. 65)
●Your unit memorises all detected stations even if reception of
some of them is poor. You can delete those stations with an
unacceptable picture. (Apg. 65, ADelete A ChannelB)
INFORMATION
Just Clock
Your unit is equipped with the Just Clock function which provides
accurate time keeping through automatic adjustments at regular
intervals, by reading data from the digital terrestrial broadcast
(DVB-T) signal. If you want to take advantage of this function,
simply set AJUST CLOCKB to AONB. (The default setting is AONB.)
(Apg. 66)
If you have any difficulty with the above procedures call the JVC
Customer Service Hot Line on 0870 330 5000.
M150SEK_00.book Page 18 Wednesday, June 15, 2005 4:04 PM