ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included hex key and your own phillips screwdriver | . |
Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly.
3/4" Tek Screw | 3/4" Screw | 1" Tek Screw | Cover Screw | ||
| Pulse Bar Star | Endcap Screw | Pulse Bar | Console Screw | |
3/8" Star | Washer | Screw |
| ||
Washer |
|
|
|
|
|
2 3/4" Upright Bolt | 1" Upright Bolt | 1 1/4" Bolt | |||
1. Make sure that the power cord is unplugged. | 1 |
|
|
|
|
| |
With the help of a second person, carefully tip | 75 | Wire |
|
|
| ||
the treadmill onto its left side as shown. Partially |
|
|
|
fold the Frame (26) so the treadmill is more sta- |
| 75 |
|
ble. Do not fully fold the treadmill until it is |
|
| |
|
|
| |
completely assembled. |
|
|
|
Identify the Right Upright (76), which has a |
|
|
|
sticker attached to it. Hold the Right Upright near | 76 |
|
|
the Base (81). Next, locate the long wire inside of |
|
|
|
the lower end of the Right Upright (see the inset |
|
|
|
drawing). Secure the end of the wire to the end |
| 81 |
|
of the Upright Wire (75). Then, pull the other end |
| 85 | |
|
| ||
of the wire until the end of the Wire Harness is |
|
|
|
extending from the upper end of the Right | 26 |
|
|
Upright. |
|
| |
| 83 | 84 | |
|
| ||
|
|
| |
Thread a 2 3/4" Upright Bolt (85) and a 1" Upright |
|
|
|
Bolt (84) with 3/8" Star Washers (83) into the bot- |
|
|
|
tom of the Right Upright (76). Do not tighten the |
|
|
|
Bolts yet. |
|
|
|
| 6 |
|
|
