2.With the help of a second person, carefully tip the treadmill onto its other side. Partially fold the Frame (58) so the treadmill is more stable. Do not fully fold the treadmill until it is com- pletely assembled.
Attach two Base Pads (82) to the base of the Uprights (84) with two 1” Tek Screws (83) as shown.
Insert the other Extension Leg (89) into the base of the Uprights (84) as shown. Hold two Extension Leg Nuts (67) in the bottom of the Extension Leg. Next, insert two Extension Leg Bolts (65) into the top of the Extension Leg, and firmly tighten the Extension Leg Bolts into the Extension Leg Nuts.
3.With the help of a second person, carefully raise the Uprights (84) to a vertical position.
Have the second person hold the console as- sembly near the Uprights (84) as shown. Look under the console assembly and locate the con- sole wire.
Remove the band securing the Wire Harness (77) to the right Upright (84). Next, connect the Wire Harness to the Console Wire (66). Make sure to connect the connectors properly (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and then try again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
2 |
|
| 84 |
| 82 |
| 65 |
| 82 |
| 83 |
| 67 |
| 89 |
| 58 |
3 |
|
| Console |
| Assembly |
| 66 |
| 77 |
66 |
|
77 | 84 |
4. | Insert the Wire Harness (77) and Console Wire | 4 |
| (66) into the right Upright (84). | |
| Console | |
|
| |
| Set the console assembly on the Uprights (84). | Assembly |
|
| |
| Be careful to avoid pinching the wires. While |
|
| a second person holds the console assembly, at- |
|
| tach it with four Console Bolts (64) and four Star |
|
| Washers (8) as shown; start all four Console |
|
| Bolts and then firmly tighten them. |
|
|
| 77, 66 |
|
| 8 |
|
| 8 |
|
| 64 |
|
| 64 |
|
| 84 |
|
| 84 |
|
| 7 |
