ProForm PFTL66906.0 user manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex keys		and your own phillips screwdriver	, rubber
mallet	, and adjustable wrench	.

For help identifying the assembly hardware, see the drawings below. If a part is not in the parts bag, check to see if it has been pre-assembled.To avoid damaging plastic parts, do not use power tools for assembly.

Wheel Bolt (64)–2	Console	3/4” Screw (2)–6	1” Tek Screw (39)–4
	Bolt (90)–2
		Nut (13)–2	Star
Extension Leg Bolt/			Washer (95)–8
Handrail Bolt (93)–6
3” Bolt (96)–2		Extension Leg	1/4” Star Washer
		Nut (46)–2	(73)–2

1. Make sure that the power cord is unplugged.	1
With the help of a second person, carefully tip
the treadmill onto its left side as shown. Partially			57
fold the Frame (86) so the treadmill is more sta-
ble. Do not fully fold the treadmill until it is	69
completely assembled.	93
Remove the metal packing insert from the base	95
of the Uprights (69). Insert an Extension Leg (63)			39
into the base of the Uprights (69). Hold an
Extension Leg Nut (46) in the bottom of the		95	39
Extension Leg, and thread a Extension Leg Bolt	46
(93) with a Star Washer (95) into the top of the	63		96
Extension Leg. Next, thread a 3” Bolt (96) with a
Star Washer into the bottom of the Extension leg.	86
Firmly tighten the Bolts.
Attach two Base Pads (57) to the base of the
Uprights (69) with two 1” Tek Screws (39).
	6