ProForm PFTL69502 Assembly requires the included allen wrench, Screwdriver Adjustable wrench

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench		and your own phillips screwdriver	, flat head
screwdriver	and adjustable wrench	.

1.Raise the Frame (79) to a vertical position. Be careful not to overextend the Frame.

Press the bottom end of the Shock (60) onto the bracket on the Base (118) as shown.

Press the top end of the Shock (60) onto the bracket on the Frame (79). If necessary, move the Frame (79) for- ward or backward to align the end of the Shock with the bracket. It may be helpful to use a flat head screwdriver (see the small drawing) to lift the metal clip on the end of the Shock as you press the Shock onto the bracket. Do not remove the clip. Carefully lower the Frame (79).

2.Identify the Right Upright (103), which has a Pulse Wire (121) inside of it.

Have a second person hold the Console Base (64) near the Right Upright (103) as shown. Feed the Wire Harness (90) into the indicated hole near the upper end of the right Upright and out of the hole near the lower end of the Right Upright.

Connect the Wire Harness (90) to the Base Wire Harness (126). If the connectors do not fit together easily, ro- tate them and then connect them. Insert the connectors into the Right Upright (103). Be careful not to damage the Wire Harness during steps 2 through 6.

1

79	Clip
	60

	60
	118
2	90
	Hole
	64
	121

103

126

118 90

Hole

3.Have a second person hold the Right Upright (103) and the Console Base (not shown) in a vertical position.

Hold the Right Upright (103) against the Base (118) as shown. Hand tighten two Upright Bolts (84) with Washers (125) and Star Washers (89) into the Right Upright and the Base; do not tighten the Upright Bolts yet. Be careful not to pinch the Wire Harness (not shown) inside of the Right Upright.

Attach the Left Upright (not shown) as described above. Note: There are no wires in the Left Upright.

3

103

125

118

89

84

6