ProForm PFTL69502 user manual Do not tighten the Pulse Bar Bolt yet

4.Hold the Pulse Bar (101) near the Right Upright (103). Disconnect both ends of the Pulse Wire (121) in the Right Upright from each other. Connect the wire in the Pulse Bar to the Pulse Wire. If the connectors do not fit together easily, rotate them and then connect them.

Orient the Pulse Bar (101) so that the metal pulse plates on the Pulse Bar are on the side shown by the arrow. Slide the O-ring (62) onto the end of the Pulse Bar. Insert the end of the Pulse Bar into the Right Upright

(103).Hand tighten a Pulse Bar Bolt (104) with a Washer (125) into the Right Upright and the Pulse Bar.

Do not tighten the Pulse Bar Bolt yet.

Hand tighten the other Pulse Bar Bolt and Washer into the Left Upright and the Pulse Bar (not shown). Note: There is not a wire in the left end of the Pulse Bar.

5.Locate the ground wire extending from the Console Base (64). Using the Silver Screw (124), attach the metal ring on the end of the ground wire to the small hole in the side of the Right Upright (103).

Connect the Pulse Wire (121) to the corresponding wire extending from the Console Base (64). If the connec- tors do not fit together easily, rotate them and then connect them. Insert the excess wire into the Right Upright (103).

6.While a second person holds the Console Base (64) against the Right Upright (103) and the Left Upright (not shown), tighten two 3/4” Screws (75) into each Upright.

Raise the Frame (not shown) to the vertical position so it is center between the Right Upright (103) and Left Upright (not shown). Refer to step 3. Firmly tighten the four Upright Bolts (84). Refer to step 4. Rotate the Pulse Bar (101) so the palms of your hands rest comfortably on the metal pulse plates. Firmly tighten the two Pulse Bar Bolts (104).

7.Remove the Lock Knob (92) from the Lock Pin (97). Make sure that the Lock Pin Collar (95) and the Spring

(94)are on the Lock Pin. (Note: If there are two Lock Pin Collars, place one on each side of the Spring.) Insert the Lock Pin into the Storage Latch Housing (93) and tighten the Lock Knob onto it.

4
101
62			103
121			125
			104
5
64
		Ground
			Wire
124
			90
121
			103
6
	64		103
			75
7
			95
92			94
			95
15	93		97

8.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 21). To protect the floor or carpet from damage, place a mat under the treadmill.

7