ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires your own phillips screw-

driver and rubber mallet .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1. With the help of a second person, carefully raise the

1

 

 

 

Uprights (69) to a vertical position.

 

 

 

 

 

 

 

Insert a Handrail Extension (66) into the post on the right

 

76

 

81

 

 

 

 

 

67

 

Upright (69) as shown; make sure that the indicated holes

 

Tab

 

are on top. Tap the Handrail Extension with a rubber mallet

 

 

 

 

 

 

69

to fully insert it. Attach the Handrail Extension with two 3/4”

Cutout

 

 

Screws (67) as shown.

 

 

 

 

Identify the Right Foam Grip (75), which has a large cutout

 

 

 

Post

 

 

Holes

 

in the left side for the Pulse Bar (76). Slide the Right Foam

 

 

 

 

 

66

 

Grip as far as possible onto the post on the right Upright

75

 

 

67

(69). (Note: It may be helpful to apply soapy water to the

 

 

 

Handrail Extension [66].) Make sure that the tab on the

 

 

 

 

Foam Grip is inserted into the Console Base (81).

 

 

 

 

2. Make sure that the edge of the Right Foam Grip (75) is

2

 

 

 

under the Console Base (81) as shown. Tighten a 3/4”

 

 

 

 

 

 

 

Screw (67) into the side of the Right Foam Grip as shown.

 

 

 

81

Note: It may be necessary to pull the Foam Grip out

 

 

 

 

 

 

A

slightly (see arrow A) to align the Screw with the hole in

 

 

 

 

 

 

 

the post.

 

 

 

 

Attach the other Handrail Extension (not shown) and the

 

 

75

67

Left Foam Grip (not shown) as described in step 1 and

 

 

 

 

 

 

 

 

 

this step.

 

 

 

 

 

 

 

 

67

3. Attach the Latch Assembly (11) and the Latch Spacer

3

 

 

 

(71) to the Left Foam Grip (65) with the two Latch Screws

 

 

 

 

 

 

 

(70) as shown. Note: Tighten the Latch Screw indi-

 

 

 

 

cated first.

 

 

 

 

 

65

 

 

 

 

71

 

 

 

 

11

 

 

70

 

 

 

 

 

First

70

 

 

6

Page 6
Image 6
ProForm PFTL69720 user manual Assembly, Driver and rubber mallet, As shown. Note Tighten the Latch Screw indi Cated first