®

Installation & Operating Instructions

 

 

 

Owner’s Reference PowerPack 1500 MKII

 

 

 

 

2.3 Installation

Before installation, please read and understand the following instructions:

 

Placement

 

The UPS must be installed in a protected environment away from heat-emitting

 

appliances such as a radiator or heat register. Do not install this product where

 

excessive moisture is present.

 

 

 

 

 

 

 

 

 

 

 

 

Ventilation

The location should provide adequate air flow around the UPS with one inch minimum clearance on all sides for proper ventilation.

Charge the Battery

Your new UPS may be used immediately upon receipt. However charge loss may occur during shipping and storage. So charging the battery for at least 8 hours is recommended to insure that the battery is fully charged.

To recharge the battery, simply leave the unit plugged into an AC outlet. (This UPS will recharge in both the On and the Off status.)

Connect to AC

Make sure that the voltage and frequency are correct. Plug the UPS into a 2 pole, 3 wire grounding receptacle (wall outlet). Make sure the wall outlet branch is protected. Avoid using extension cords if at all possible. If used, make sure the extension cord is rated for 15 Amps.

For 220/230/240V versions: Swap the input power cord of the equipment to the inlet of UPS. Use the power cord supplied with the UPS to connect from the outlet of the UPS to your equipment.

Determining the Load:

1. Make a list of all equipment that requires protection.

4826 Sterling Drive, Boulder, CO 80301

 

PH: 720.406.8946 service@psaudio.com www.psaudio.com

Getting Started 7

©2009 PS Audio International Inc. All rights reserved.

Page 7
Image 7
PS Audio 1500 MKII manual Installation, Ventilation, Charge the Battery, Connect to AC, Determining the Load