11.5To View The Setpoint
∙Push and release the SET key to see the set point value.
∙To return to normal display, press SET + UP or wait 15 seconds without pressing any key.
11.6To Change The Setpoint
∙Push the SET key. The upper display will show the “St1” parameter name, while the lower display will show its value.
∙Use the UP or DOWN key to cycle through the parameter names.
∙Push the SET key to modify a parameter value. The value starts flashing in the lower display.
∙To change it push the UP or DOWN keys. Push the SET key again to confirm the value and pass to the setting of next set point.
∙Repeat the operations described at points 3, 4, 5.
∙To Exit: press SET + UP or wait 15 seconds without pressing any key
NOTE: Each point has a time out of 15 seconds. If any key is pushed within 15 seconds the controller exits the set points programming procedure.
NOTE: The set value is stored even when the procedure is exited by waiting the
11.7To Change Other Parameters
∙Push the SET and DOWN arrow simultaneously for 3 seconds.
∙Select the required parameter. The name of the parameter is on the upper display; its value is on the lower display.
∙Press the SET key: the value of the parameter will start blinking.
∙Use UP or DOWN to change the value.
∙Press SET to store the new value and move to the following parameter.
∙To Exit: Press SET + UP or wait 15s without pressing a key.
22
