PDWM-2600
DUAL UHF WIRELESS MICROPH0NE SYSTEM
OPERATION MANUAL
Thanks for your support and trust to us while choosing our wireless microphone series with excellent quality. To ensure it functions well, Please read this manual carefully before operation.
PDWM-2600
Avoid exposure of the system to rain or moisture.
No
Handle the microphone carefully, dropping or other shocks may cause failure.
Avoid using the system where it may be subjected to heat, such as in direct sunlight, near radiators or other heat sources.
Should any liquid be spilt on the system, stop using it immediately. It may be possible to dry the system, but you should have it checked by a quali- fied technician before using it again.
Take care with the mains power adapter and lead. If damaged in any way, do not use the system, and refer to a qualified technician for repair.
Only use the system with the supplied components, do not attempt to use with any other mains power supply adapter .
If the microphone is not going to be used for a time, remove the
battery to prevent leakage. In the event of electrolyte leakage inside the
RECEIVER UNIT/operation
DUAL UHF WIRELESS MICROPH0NE SYSTEM
ANT | MIX | DC 12V | ANT |
|
|
| |
|
| SQUELCH |
|
BALANCED | AF. OUT |
| BALANCED |
AERIAL. B | OUTPUT JACK DC POWER IN | AERIAL. A | |
DUAL UHF WIRELESS MICROPH0NE SYSTEM
battery compartment, carefully remove using a damp cloth. Take care not to get battery electrolyte in contact with your skin, however, if it does, wash your hands under a running tap. If electrolyte comes into contact with your eyes, seek medical advice immediately.
Only replace the battery with the same or an equivalent type.
Please dispose of old batteries in an environmentally friendly manner in accordance with the relevant legislation.
Do not use any solvents to clean any part of the wireless microphone system .
OPERATION
Switch on the wireless microphone receiver unit by pressing the POWER switch and the POWER light will illuminate to show the receiver unit is working. Raise the aerials to the maximum height. The positioning of the aerials is not critical for performance; ideally it should be fully extended. Switch ON the microphone, checking that the red LED comes on for a second and then goes off. When the microphone is ON, the SIGNAL light will illuminate on the receiver unit.
The wireless microphone is now ready for use; adjust the volume and tone levels of your amplifier system as well as the receiver & the handheld mic as required. When the wireless microphone is not being used, turn OFF the microphone.
Note that switching the microphone on and off can cause interference that will be heard if the microphone volume level of the amplifier system is still set high.
