PYLE Audio PLR7N manual Setting the Camera, Watching the Back View Picture, Wiring Connection

CAMERA IN

SETTINGTHECAMERAIN

1. Connect a Back View Camera video output	to AV1,2 or 3 video Input terminals on
the rear of the unit.

*When the VCD changer is connected to AV3 Video input, The back view camera can be connected only to AV1 or AV2 video input.

2.Press the MODE button to select radio mode.

3.Press the MENU button to select following picture.

RADIO SUB MENU

4. Press the SEARCH UP/DOWN button to select CAMERA IN.

5. Press the VOLUMEbutton to select AV1,2 or 3 mode that Back View Camera is connected. Each time you press this button, AV Input changes as AV1 -> AV2 -> AV3 -> OFF

WATCHINGTHEBACKVIEWPICTURE

Set the rear gear on any mode. The monitor shows the back view camera picture.

WIRINGCONNECTION

Connect orange color connection wire named “REVERSE GEAR” to a switched power output terminal of the R (reverse) gear.

See page 26: BASIC CONNECTIONS.

NOTE

If AV input connected to the Back view Camera is selected with the MODE button, the monitor does not show the back view camera picture.

The Monitor shows only the WARNING picture.

16