For switch position 5, if the switch is set to ON, the busy signal is sent to host only when input buffer is full. When it is set to OFF, busy signal is sent to host whenever an off line status occurs. Therefore, signals including the paper near end detect will generate busy signal to the host. Consequently, the printing may be stopped even when there is still a long way to go before the paper roll is actually exhausted. Taking the paper out beep into consideration, the printer will keep on beeping at Paper End (completely no paper) till paper is replaced when
For switch position 6, when it is set to OFF, there will be a 20 mm paper feed before cutting when software does not define this point and there will be further 10 mm paper after cutting to prevent paper jam. Before setting this switch to ON, please make sure that your software will take care of enough paper feed for the paper jam prevention issue.
For switch position 8, when it is set to ON in the field, the printer maybe subject to unpredictable damages and must be strictly prevented.
The factory default for each position is listed below:
Switch Position | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
Serial interface w/ | OFF | OFF | OFF | OFF | OFF | OFF | OFF | OFF |
auto cutter |
|
|
|
|
|
|
|
|
Parallel interface w/ | ON | ON | OFF | OFF | OFF | OFF | OFF | OFF |
auto cutter |
|
|
|
|
|
|
|
|
C. ADVANCED SETTINGS
Please consult your system integrator once any advanced settings like that for using 38 mm width paper roll in
5 - 4
